Hardware Setup and Configuration Programs
Here are the programs you need to set up and configure your Invisible LAN network hardware.
Ethernet 2000 Series Setup Programs
The following programs are used to set up the software-configurable adapters in the Ethernet 2000 series.
| Filename | Description |
|---|---|
| SETUPS.ZIP (34K) |
Setup program for the Ethernet 2000S adapters. These are jumperless adapters that can be configured to be either NE-2000 compatible or WD-8013 compatible. They can be identified by the presence of a large controller chip marked with the part number "DP83905" or "W89C905". |
| SETUPJ.ZIP (33K) |
Setup program for the Ethernet 2000JA, 2000JC, and
2000JT adapters. These are jumperless adapters that are NE-2000 compatible. They can be identified by the presence of a bar code on the back of the board that begins with the characters "2000J". |
| SETUPR.ZIP (39K) |
Setup program for the Ethernet 2000RA and 2000RC
adapters. These are NE-2000 compatible Ethernet adapters, configurable with software or jumpers. They can be identified by the presence of a bar code on the back of the board that begins with the characters "2000R" or "NE2000R". |
| SETUPP.ZIP (58K) |
Setup program for the Ethernet 2000PXA and 2000PXC
adapters. These are NE-2000 compatible Ethernet adapters, configurable with software or jumpers. They can be identified by the presence of either (a) a bar code on the back of the board that begins with the characters "2000PX", or (b) the number "2976033303" printed inside the ROM socket. |
Need additional help figuring out which adapter you have? Go to our Support FAQ section, and look at the FAQ on "Invisible Ethernet 2000 Model Identification".
Ethernet PCMCIA Setup Program
The following program is used to set up and activate the Invisible Ethernet PCMCIA adapters.
| Filename | Description |
|---|---|
| CARDGO.ZIP (4K) |
Setup and activation program for the Ethernet PCMCIA
adapters. There have been several different models of Ethernet PCMCIA adapters, but CARDGO can be used for all of them. This program activates the adapter, and optionally sets the I/O address and interrupt level. |
Need additional help? Go to our Support FAQ section, and look at the FAQ on "PCMCIA Adapter Trouble-Shooting".
Micro Channel Adapter Description Files
These are the adapter description files (ADF files) that are use to set up Micro Channel network boards sold by Invisible Software.
| Filename | Description |
|---|---|
| ADF5347.ZIP (2K) |
Adapter description file for Invisible Ethernet/A. These old Ethernet adapters are not NE/2 compatible. |
| ADF5348.ZIP (2K) |
Adapter description file for Invisible Network Model
300/A. These old adapters run at speeds from 0.7 to 3.0 Mbps, on dual twisted-pair wire. They are not Ethernet adapters. |
| ADF5349.ZIP (2K) |
Adapter description file for Invisible Network Model
200/A. These old adapters run at speeds from 0.7 to 1.8 Mbps, on dual twisted-pair wire. They are not Ethernet adapters. |
| ADF7154.ZIP (1K) |
Adapter description file for Invisible Ethernet-2/A. These old Ethernet adapters are NE/2 compatible. |
Go back to
Utilities and Patches